- Unit for the opposite side punching holes into round and rectangular tubes
- Maximum outside diameter of round tube 28 mm
- Maximum hight of rectangular tube 28 mm
- Maximum width of rectangular tube 28 mm
- Maximum punch diameter 11,1 mm
- Minimum die clearance 0,3 mm
- Minimum wall thickness 0,8 mm
Note:
Hole in the upper side is with deformation, because inside of tube is not die. Deformation depend on diameter of hole, outside diameter of tube, wall thickness and material of tube and it can be very different.
Hole in the bottom part is without deformation.
In order is necessary specify diameter of tube and hole, wall thickness and material.
| Parts of unit MTP-50 |
Cat. No |
| No |
Part |
Round |
Rect. |
| 1 |
Holder |
8355 |
|
| 2 |
Punch |
8211 |
|
| 3 |
Die |
8220 |
8221 |
| 4 |
Guide |
8235 |
8236 |
| 5 |
Stripping spring |
8240 |
|
| 6 |
Liter Spring |
8270 |
|
| 7 |
Punch Head |
8275 |
|
| 8 |
Pilot Pin Short |
1001 |
|
| 8a |
Pilot Pin Long |
5012 |
|
| 9 |
Die Retainer Pin |
5023 |
|
| 10 |
Punch Retainer Pin |
2180 |
|
| 11 |
Guide Retainer |
1018 |
|
| 12 |
Guide Retainer Pin |
1019 |
|
Datasheet download HERE.